Motor assembly workers safe operating procedures

The general rules for motor assemblers are as follows: 1. Prior to work, arrange the site, stabilize all zero parts and components, and check if the assembly tools and work environment are safe. 2, lifting the motor base, floor, stator, rotor, bearings and other large parts must be put square box or mat. It is forbidden to operate under the suspended objects and should be closely linked with the mechanics and pedestrians. 3, the motor rotor balancing to comply with the "dynamic balancing machine safety rules." 4, set the stator before the motor rotor must be placed smooth, pad firmly, to prevent dumping. Motor assembly line 5, in the stator and bearing seat floor when not allowed to put aside pad gasket. 6, the use of hand hammer and sledgehammer must be equipped with a solid wood inverted wedge. Do not wear gloves when hammering, and pay attention to whether there are people before and after. 7, when drilling positioning hole to comply with "drilling safety operating procedures." With portable drilling machine must be padded smooth. 8, with the test to be close contact with the test staff, and to comply with "Electrical Test Safety Operating Procedures." Test platform and motor oil to be wiped clean. Across the springboard, climb the shelf and up and down the ladder to be installed securely. 9, the use of hand-held power tools must comply with the relevant safety regulations. 10, flammable and explosive materials to be properly kept, do not litter, indiscriminate release is strictly prohibited fireworks or high temperature. 11, the motor assembly, the fingers can not be placed in the gap between the cover and the base to prevent injury when closed. When assembling screws, do not try to reach into the hole with your fingers. 12, when wearing bearing gloves to prevent heat burns. 13, with flammable items is prohibited when cleaning the bearings close to. Kerosene heating temperature shall not exceed 60 ℃. Cleaning facilities must have good ventilation. 14, install the rotor should pay attention to the pivot pin keyway burr to prevent the fingers were cut. 15, assembly motor move or move on the workbench, should pay attention to the safety of the personnel around